When you Cut a commandgroup or command in the command tree and paste it somewhere else, the paste works, but the original command group or command stays also in it's previous location.
Just so you know James, small detail I know ;)
I can't replicate this behaviour. Seems to work fine here. Are there specific steps that you need to take for this to happen?
Nop I just select a command, right click then choose CUT, and afterwards PASTE and the original stays.
PS : lol -> The last posting from your IP was less than 90 seconds ago. Please try again later.
I'm so not gonna get used to this :p
I bet if you'd put the e in nope it would have taken 90 seconds...
Quote from: Auri on February 20, 2011, 10:48:55 AM
Nop I just select a command, right click then choose CUT, and afterwards PASTE and the original stays.
Does this happen to anyone else?
Quote from: jitterjames on February 20, 2011, 11:19:00 AM
Does this happen to anyone else?
Yes James, i have the same too.
Cut a command -> paste in an other folder, and the cut command stay also
OK, Thanks guys. I think I fixed it.
Quote from: jitterjames on February 20, 2011, 04:43:36 PM
OK, Thanks guys. I think I fixed it.
Nice James, it is nothing major, but good you fixed the problem.