standby

[mparks]

What's the most efficient way to do this.

After I give vox a command, and it completes it I want it to asked me
"is there anything else I can do" if I say YES then vox stays in active mode but if I
say NO then vox goes into standby mode .

Any suggestions?

[Kalle]

What's the most efficient way to do this.

After I give vox a command, and it completes it I want it to asked me
"is there anything else I can do" if I say YES then vox stays in active mode but if I
say NO then vox goes into standby mode .

Any suggestions?

you need a logic command as confirm marked (in command builder upper right) I can give you a example later when I'm home  

forget this way 

[Kalle]

What's the most efficient way to do this.

After I give vox a command, and it completes it I want it to asked me
"is there anything else I can do" if I say YES then vox stays in active mode but if I
say NO then vox goes into standby mode .

Any suggestions?

Ok, the easy way to do it is fire a "event" after each command in that you need this feature. (I'm sure you are not using it in any command    )
You can open my "mparkstest.xml" in the right of command editor - drag and drop both groups in your command tree.
The "current time" command  say the current time and trigger a event that is in the "ON or Standby" command group.

to use this example say: "current time"

VC speak the current time and ask you "is there anything else I can do"

you can say "No" then VC go in standby mode or "Yes" and VC stay in ON mode.

The "current time" is a example that show you which parameter you need in the command (VC.TriggerEvent)

If you have a questions let me know.

Kalle

[mparks]

This is perfect, just what I was trying to do. Thank you so much..... 

[Kalle]

This is perfect, just what I was trying to do. Thank you so much..... 

nice to hear that is the right thing